TAN Wen
,
HAN Bin
,
WANG Shui-ze
,
YANG Yi
,
ZHANG Chao
,
ZHANG Yong-kun
钢铁研究学报(英文版)
Effects of chemical compositions, finish rolling temperature, isothermal temperature on runout table and coiling temperature on microstructure and mechanical properties of economical dual phase steel produced on CSP line were investigated. Experimental results showed that martensite volume fraction could be enhanced and banding microstructure could be reduced by controlling Mn, Si contents and applying proper finish rolling temperature. Optimized processing-parameters were obtained for DP580 production on CSP line of Wuhan Iron and Steel (group) Co (WISCO) in China. Optimal microstructure and mechanical properties could be achieved when the strip was finished rolling at the range of 790 to 830 ℃, isothermally holding at 680 to 740 ℃ and coiling below 250 ℃.
关键词:
economical dual phase steel
,
mechanical property
,
banding microstructure
,
processing-parameter
XU An-jun
,
ZHANG Hui-ning
,
YANG Yi
,
CUI Jian
,
HE Dong-feng
,
TIAN Nai-yuan
钢铁研究学报(英文版)
Abstract： In order to study calcium leaching behavior for the steelmaking slag, factors that influence the leaching yield have been optimized. The results show that granularity of the slag, liquid to solid ratio (in short for L/S), temperature and reaction time have a significant effect on the leaching yield. The optimal conditions for leaching are determined as follows: 1) the granularity at 75 μm, L/S at 100, temperature at 60 ℃; 2) the granularity at 75 μm, L/S at 50, temperature at 40 ℃. Finally, the optimal leaching yield under these conditions is about 15%.
关键词:
Key words: steelmaking slag
,
leaching yield
,
calcium content
